Wire Glue - Conductive paint
Power Feed Joiners Code 100 & Code 124
And to extend your control panel-that's simple too! Simply slots into the side of the PL-50.
Turnout Motor (Extended Pin) Designed for use with PL-9 mounting plate. Use this if you do not wish to cut a large hole in your baseboard. Drill a hole, 9.5mm (3/8in) through the baseboard beneath the centre of the tie bar.
White passing contact switch
Power Feed Joiners Code 55/80
Clipped onto Peco Streamline OO/HO track to bridge isolating gaps.
The PL-12 Adaptor Base should be used in association with most non-PECO turnouts, where the over-centre spring feature is not available. It can be affixed above or below the baseboard, and give the modeller the ability to "lock" the point blade in either position when used in conjuction with the PL-10 Turnout Motor.
Switch Mounting Plate
Yellow passing contact switch
6 Pin Decoder Socket with 8 Pin Plug x 3