Studs and Tag Washers, for use with probe
The PL-12 Adaptor Base should be used in association with most non-PECO turnouts, where the over-centre spring feature is not available. It can be affixed above or below the baseboard, and give the modeller the ability to "lock" the point blade in either position when used in conjuction with the PL-10 Turnout Motor.
Easy to assemble unit with two microswitches to control the polarity of live frogs whilst simultaneously operating panel indicator lights. Complete with illustrated instructions. Rated 2.5 amps.
Turnout Motor (Extended Pin) Designed for use with PL-9 mounting plate. Use this if you do not wish to cut a large hole in your baseboard. Drill a hole, 9.5mm (3/8in) through the baseboard beneath the centre of the tie bar.
On Off Switch
Working Buffer LightDC or DCC Compatible Easy To Install No Soldering Required Buffer Stop Not Included
Allows switches to be ganged together and operated simultaneously.
Extend the length of any Just Plug Cable. 2 x 48" Connecting Cables/pkg
Point Extension Cable
2x5mm clear LED + 12V resistor 2 x Clear (White) 5mm LED -for 4-5volt operation, but supplied with the correct resistor for 12 volt operation.