Valid to UK only - excludes oversized items
Track gauges of this type don't look like much when you take them out of the box and it's often hard to see how to...
7/0.2 wire is what railway modellers most commonly use for wiring auxiliary features to their layouts and to carry...
For those not in the know, rail joiners are the little metal clips (sometimes referred to as fishplates) that connect...
A model clamp is a lightweight clamp (or series of smaller clamps) designed to hold the parts of a model together or...
AReady to Run (RTR) wagon refers to a model railway wagon that comes fully assembled and decorated straight from the...
Enamel or acrylic, but also varnish or weathering : the best choice for each case.
Click here to receive the tips weekly in your mailbox. You can unsubscribe at any time.
The best paint to use on a metal locomotive kit depends on your personal preference and the desired finish. Here are a few options to consider: Acrylic paints: These are water-based paints that are easy to clean up and dry quickly. They come in a...
Acrylic paint is widely used by hobbyists as it offers many advantages. It is water soluble which removes the need for hazardous and flammable thinners and cleaners, also it is produced by a wide range of manufacturers and so is relatively...
Liquid Masks are latex-based liquid masking solutions, generally supplied in a small bottle. They are a viable and practical alternative to masking tape for masking tricky items. They are generally cheap and if used with prudence a single bottle...
Enamel-based paints can be used in an airbrush but they need more specialised equipment and techniques to use. Enamel paints are oil-based and dry slower than water-based paints.This can make them trickier to work with in an airbrush. Here are...
The ideal type of finish chosen by a modeller for painting a model railway locomotive will largely depend on personal preference and the level of realism the modeller is aiming to achieve. However, here's a general overview of the different types...
White metal figures are typically painted using oil-based or enamel paints. These types of paints have a higher viscosity and are slower-drying than other types of paint, which allows for more time to work on the details of the figure and achieve...
Bare metal can be a very difficult colour to paint well as it has a habit of showing up any imperfections very clearly. Additionally, bare metal comes in a surprising array of colour tones that are all subtly different. Historically many modellers...
When painting a surface, it's important to use a primer before applying the topcoat. The primer acts as a base coat that helps the topcoat better adhere and provides a smooth surface for the paint to be applied to. In some cases, it may be...
Many of the most famous landmarks and buildings worldwide are noticeable for having a distinctive bluish-green colour on exposed surfaces and roofs. This distinctive colouration is called a patina and typically can occur on surfaces including...
When painting a model it is always possible that paint can seep underneath masking tape and thus ruin the painting effect. That said, with careful preparation, this should be relatively easy to avoid. The following tips offer some guidance as to...
When painting natural metal surfaces on a model, it is generally recommended to use a grey or white primer. Grey or white primers provide a neutral base for the metallic paint, allowing the metallic pigments to stand out without being affected by...
The purpose of a flow retarder when airbrushing is to slow down the drying time of the paint in the airbrush, allowing for a more controlled and consistent coverage. Flow retarder is a liquid medium that is added to the paint before airbrushing....