Micro Sol for softening decals

Micro Sol is used for softening decals/transfers so they conform better to the kit. Say you want your transfers to fit into or over the panel lines of your Spitfire, this is the solution you need.

Size: 1floz (about 30ml)

Micro Sol setting solution is for the most difficult irregular surfaces to be found on models. It completely softens the Microscale Decal, allowing it to drape down onto the surface of the model, conforming perfectly to surface irregularities without distortion. The most amazing results in seemingly impossible places are possible because Micro Sol actually makes the decal part of the painted surface.

For the best results, first apply Micro Set to your model to prepare the surface and enhance the adhesive (make sure the surface is free of particles or dust). Once dry, you can apply your decal in the usual way. Once everything is dry enough that the decal will not move easily, apply Micro Sol with a small flat brush. Apply with as few strokes as possible so as not to disturb the decal. Then allow the decal to dry without disturbing it. One application is enough in most cases but, if necessary, a second application of Micro Sol can be helpful. Following these simple instructions will result in a model with professional looking markings.