DCC Control Unit for Dapol's motorised junction signals

DCC Control Unit for Dapol's motorised semaphore junction/bracket signals.

This DCC control unit should be used if you have a Dapol motorised semaphore junction signal on your layout and wish to operate it via the keypad on your DCC controller. The unit is capable of operating either arm on the signal independently.

Installation is simple as the unit connects directly to the track and the signal with no additional wiring, switches, power supply or resistors required. The screw terminals on the unit are colour coded and labelled specifically to connect with Dapol's motorised junction signals so you don't have to worry about complicated wiring.

Full instructions are included to help with installation and the special 'learn' button on the unit means no complicated programming is needed as the unit will communicate with your controller at the setup stage.
All you need is a Dapol motorised junction/bracket signal and a DCC controller capable of operating accessories via the keypad and your signal will be up and operating in no time!