LED Green 3mm (Pack of 5) 12vPack of 5 light emitting diodes. Use with GM76 resistors
LED Red 3mm (Pack of 5) 12vPack of 5 light emitting diodes. Use with GM76 resistors
And to extend your control panel-that's simple too! Simply slots into the side of the PL-50.
The PL-12 Adaptor Base should be used in association with most non-PECO turnouts, where the over-centre spring feature is not available. It can be affixed above or below the baseboard, and give the modeller the ability to "lock" the point blade in either position when used in conjuction with the PL-10 Turnout Motor.
As easy as 1-2-3. Insert PL-26 switches into the slots of the PL-50unit. PL-51 add on units can be easily added on the side. No soldering makes changes easy and safe for modellers of all ages.
21-pin E-Z Command 4-function 1A decoder with back EMFDCC Ready. 21-pin socket
DCC controller - Prodigy Express Package Comprising of a Base Station, Walkaround, and Power Supply, this system is packed with features but is above all, incredibly easy to use and allows you to run your railway without fuss.
Power Feed Joiners Code 55/80
Power Feed Joiners Code 100 & Code 124
2x5mm clear LED + 12V resistor 2 x Clear (White) 5mm LED -for 4-5volt operation, but supplied with the correct resistor for 12 volt operation.
LED Yellow 3mm (Pack of 5) 12vPack of 5 light emitting diodes. Use with GM76 resistors